User Manual

Model Assembly Continued

Wing Installation

1. Slide the wing tube into the fuselage.

2. Slide the wings onto the wing tube.

3. Secure the wing halves into position from the bottom

using the four included 3 x 16mm counter sunk machine screws

(2mm hex driver required).

Disassemble in reverse order.

Vertical Stabilizer Installation

1. Connect the rudder servo on one vertical stabilizer to the servo extension in the fuselage.

2. Connect the rudder servo to the servo lead located in the pocket where the rudder mounts.

3. Tuck the servo lead back into the pocket and slide the vertical tail into place.

4. Secure the vertical tail with two 3mm x 16mm counter sunk machine screws

(2mm hex driver required).

5. Repeat this process for the second vertical stabilizer.