User Manual

 1. Slide the rudder into position on the fuselage.
The threaded rods extend through the bottom
of the fuselage.
Tail Installation
Required Parts
• Fuselage
• Rudder/Fin
• Stabilizer/Elevator
• 3mm locknut (2)
• 3mm washer (2)
Required Tools and Adhesives
• Nut driver: 1/4"
Note: Before installing the tail, check to
make sure the hinges are glued securely by
gently pulling on the two surfaces. If they are
not glued securely, apply thin CA to both
sides of the hinge to secure them. Do not
use accelerator. The CA must be allowed to
soak into the hinge to provide the best bond
between the hinge and surrounding wood.
16