User Manual

 2. Attach the stabilizer using two 3mm washers and
two 3mm locknuts. Do not tighten the locknuts all
the way until after the wing is installed and you
check the alignment.
Note: The tail section is removable for easy
transporting if needed.
Wing Preparation
Required Parts
• Wing
• 6-channel receiver
• Servo w/hardware (2)
• Servo extension, 6" (2)
• Clevis (2)
• Pushrod connector (2)
• 5
5
/
8
" (143mm) pushrod wire (2)
Required Tools and Adhesives
• Drill
• Drill bit: 1/16" (1.5mm), 5/64" (2mm)
• Screwdriver, #0 Phillips
• Pliers
Note: For the optional Quad Flap modification,
please refer to information on Page 20.
Note: Check to make sure the aileron hinges
are glued securely by gently pulling on the two
surfaces. If they are not glued securely, apply
thin CA to both sides of the hinge to secure
them. Do not use accelerator. The CA must be
allowed to soak into the hinge to provide the
best bond between the hinge and surrounding
wood.
17