User Manual

Quad Flap Modification (Optional)
Optional Parts (for Quad Flaps)
• Servo w/hardware (2 additional needed)
• Servo extension, 18" (2)
• Clevis (2)
• Pushrod connector (2)
• 5
5
/
8
" (143mm) pushrod wire (2)
• Control horn (2)
Required Tools and Adhesives
• Hobby knife
• Covering iron
• Drill
• Felt-tipped pen
• Drill bit: 1/16" (1.5mm), 5/64" (2mm)
• Screwdriver, #0 Phillips
• Pliers
The Ultra Stick 25e wing is designed with optional quad
flaps. The ailerons have been designed with the option
of cutting them in half using a hobby knife. Covering has
been supplied to cover the cut ends. Installing the servos is
similar to that of the aileron instructions above. There are
some additional changes.
 1. Remove the covering from the opening in
the wing for the aileron servo using a sharp
hobby knife.
21