User Manual

 6. Follow the procedure outline in the aileron
section to mark the pushrod, bend it and attach
it to the servo horn.
Note: Use side cutters to trim down the excess
pushrod wire and remove the extra arms from
the servo horn.
 7. Use a hobby knife or razor saw to separate the
aileron from the flap. Use the covering provided
with the model to seal the ends where the two
were separated.
Note: See our Ultra Stick 25e website page
for radio tips for quad flap operation using this
setup. There are also options listed if you use
a 6-channel transmitter and receiver. However,
this method will require the purchase of a
reversed servo and the use of a Y-harness to
connect your two inner location servos.
24