User Manual

SAFE

Select Switch Designation

SAFE

Select technology can be easily assigned to any open switch on your

transmitter. With this new feature, you now have the ﬂexibility to enable or dis-

able the technology while in ﬂight.

IMPORTANT: Before assigning your desired switch, ensure that the travel for

that channel is set at 100%.

Assigning a switch

1. Bind the aircraft correctly to activate SAFE Select. This will allow the

system to be assigned to a switch.

2. Hold both transmitter sticks to the inside bottom corners and toggle the

desired switch 5 times to assign that switch. The control surfaces of the

aircraft will move, indicating the switch has been selected.

Repeat the process to assign a different switch if desired.

NOTICE: SAFE Select is assignable on Channels 5–9.

Mode 1 and 2 Transmitters

x 5

AS3X Control Direction Test

This test ensures that the AS3X

control system is functioning properly.

Assemble the aircraft and bind your transmitter to the receiver before

performing this test.

1. Raise the throttle just above 25%, then lower the throttle to activate AS3X

technology.

CAUTION: Keep all body parts, hair and loose clothing away from a

moving propeller, as these items could become entangled.

2. Move the entire aircraft as shown and ensure the control surfaces move

in the direction indicated in the graphic. If the control surfaces do not

respond as shown, do not ﬂy the aircraft. Refer to the receiver manual for

more information.

Once the AS3X system is active, control surfaces may move rapidly. This is

normal. AS3X remains active until the battery is disconnected.

Aircraft

movement

AS3X Reaction

ElevatorAileronRudder