User Manual

Model Assembly

Main Landing Gear Installation

1. Remove the battery compartment door (A) from the bottom of the fuselage.

2. Slide the pre assembled landing gear (B) into the fuselage as shown.

3. Secure with four 3mm x 12mm washer-head self-tapping screws (C) using a

Phillips screwdriver.

4. Re-install the battery hatch.

Tail Installation

1. Install the vertical stab (A) over the horizontal stab (B) by sliding the 2 plastic

tabs down through the holes in the horizontal stab, creating a complete tail

assembly.

TIP: You may wish to secure the vertical and horizontal stabs with a thin piece of

double sided tape.

2. Place the tail assembly (C) onto the fuselage by ﬁrst inserting the front of the

vertical stab into the fuselage.

3. Lower the back of the assembly down onto the fuselage, lining up the 2

plastic tabs with the 2 holes in the fuselage.

4. Secure the tail with two 2.5mm x 20mm self-tapping screws (D) inserted

from the bottom of the fuselage and one 2mm x 8mm self-tapping screw

(E) into the tail wheel bracket as shown. Secure the screws in place using a

Phillips screwdriver.

IMPORTANT: DO NOT over tighten the screws.

5. Attach the clevis to both the elevator and rudder control horns (see

instructions for clevis connection).

Tail Wheel Installation (If needing to replace and

install tailwheel)

1. Slide the tail wheel assembly (A) into the slot in the bottom of the rudder as

shown.

2. Rotate the assembly until it locks into the clamps moulded into the tail wheel

bracket.