User Manual

Valiant

™

1.3m

Model Assembly Continued

Wing Installation

1. Slide the 1 large (A) and 1 small (B), carbon ﬁber wing tubes into one wing

half and then join the 2 halves together.

2. Connect the ﬂap and aileron connectors (C) to respective Y-harnesses

connected to the receiver. The left and right servos can be connected to

either side of a Y-harness.

IMPORTANT: The ailerons must be connected to the receiver’s AIL (channel 2)

with a Y-harness (included) for the AS3X system to function properly.

3. Carefully lay the wing assembly on top of the fuselage and secure with the

wing cover and four M3 x 12mm machine screws as shown. Secure the

screws in place using a Phillips screwdriver.

CAUTION: DO NOT crush or otherwise damage the wiring when attaching

the wing to the fuselage.

Ailerons

Flaps