User Manual

Battery Selection

We recommend the Spektrum

™

2200mAh 11.1V 3S 30C Li-Po battery

(SPMX22003S30). Refer to the Optional Parts List for other recommended

batteries. If using a battery other than those listed, the battery should be within

the range of capacity, dimensions and weight of the Spektrum Li-Po battery

packs to ﬁt in the fuselage. Be sure the model balances at the

recommended CG.

1. Lower the throttle and throttle trim to the lowest settings. Power on the

transmitter, then wait 5 seconds.

2. Unlock and lift the back of the battery hatch (A) to remove.

3. For added security, apply the loop side (soft side) of the optional hook and

loop tape (B) to the bottom of your battery and the hook side to the battery

tray.

4. Install the fully charged battery (C) all the way forward in the battery

compartment as shown. Secure using the hook and loop strap (D).

5. Connect the battery to the ESC (the ESC is now armed).

6. Place the aircraft on its wheels with wings level

7. Keep the aircraft immobile and away from wind or the system will not

initialize.

• The ESC will sound a series of tones (refer to step 7 of the binding

instructions for more information).

• An LED will light on the receiver.

8. If the ESC sounds a continuous double beep after the ﬂight battery is

connected, recharge or replace the battery.

9. Reinstall the battery hatch.

Battery Installation and ESC Arming

CAUTION: Always

keep hands away

from the propeller. When

armed, the motor will turn

the propeller in response to

any throttle movement.

Optional