User Manual

Timber

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo

arms. Fly the aircraft at factory settings before making changes.

NOTICE: If control throws are changed from the factory settings, the AR636

gain values may need to be adjusted. Refer to the Spektrum AR636 manual for

adjustment of gain values.

After ﬂ ying, you may choose to adjust the linkage positions for the desired

control response. See the table to the right.

Horns Arms

Elevator

Rudder

More control throw Less control throw

SAFE

Select Switch Designation

The SAFE

Select technology can be easily assigned to any open switch on

your transmitter. With this new feature you now have the ﬂ exibility to enable or

disable the technology while in ﬂ ight.

IMPORTANT: Before assigning your desired switch, ensure that the travel for

that channel is set at 100%.

Assigning a switch

1. Bind the aircraft correctly to activate SAFE select to allow the system to be

assigned to a switch.

2. Hold both transmitter sticks to the inside bottom corners and toggle the

desired switch 5 times to assign that switch. The control surfaces of the

aircraft will move indicating the switch has been selected.

Repeat the process to assign a different switch if desired.

NOTICE: SAFE Select is assignable on Channels 5–9.

x 5

Mode 1 and 2 Transmitters