User Manual

Battery Installation and ESC Arming

Battery Selection

We recommend the E-ﬂ ite

2200mAh 11.1V 3S 30C Li-Po battery

(EFLB22003S30). Refer to the Optional Parts List for other recommended

batteries. If using a battery other than those listed, the battery should be within

the range of capacity, dimensions and weight of the E-ﬂ ite Li-Po battery packs

to ﬁ t in the fuselage. Be sure the model balances at the recommended CG.

1. Lower the throttle and throttle trim to the lowest settings. Power on the

Transmitter, then wait 5 seconds.

2. For added security, apply the loop side (soft side) of the optional hook and

loop tape (A) to the bottom of your battery, and the hook side to the

battery tray.

3. Press the latch button (B) and remove the battery hatch.

4. Install the fully charged battery (C) in the center of the battery compartmant

as shown. Secure using the hook and loop straps (D).

5. Connect the battery to the ESC (the ESC is now armed).

6. Keep the aircraft immobile and away from wind or the system will

not initialize.

• The ESC will sound a series of tones (refer to step 6 of the binding

instructions for more information).

• An LED will light on the receiver.

If the ESC sounds a continuous double beep after the ﬂ ight battery is

connected, recharge or replace the battery.

7. Reinstall the battery hatch.

CAUTION: Always

keep hands away from the

propeller. When armed, the

motor will turn the

propeller in response to

any throttle movement.

Optional