Piper Cherokee 1.
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com or towerhobbies.com and click on the support tab for this product.
EN Box Contents Quick Start Information Set up your transmitter using the transmitter setup chart Transmitter Setup Travel and Dual Rates Hi Rate Low Rate Ail 16mm 10mm Ele 10mm 7mm Rud 20mm 15mm Flaps Landing Takeoff q=25mm q=15mm Center of Gravity (CG) 120mm +/-3mm back from leading edge of wing at the fuselage.
EN SAFE® Select Technology (BNF Basic) The evolutionary SAFE® Select technology can offer an extra level of protection so you can perform the first flight with confidence. No complex transmitter programming is required. Just follow the simple bind process to make the SAFE Select system active. When activated, bank and pitch limitations keep you from over-controlling and automatic self-leveling makes recovery from risky or confusing attitudes as simple as releasing the sticks.
EN Model Assembly Wing Installation IMPORTANT: The integrated servo connectors are in the wing and fuselage. Ensure that they slide together correctly. 1. Slide the wing tube into the fuselage. 2. Slide the wings onto the wing tube. 3. Secure the wing halves into position using the included 3 x 8mm screws. Disassemble in reverse order. 3 x 8mm Phillips head machine Landing Gear Installation Main Gear 2 x 16mm Phillips head machine 1.
EN Model Assembly Continued Horizontal Tail Installation 1. Remove the three 1.5 x 8mm self tapping screws holding the tail cover in place. 3. Install the tail cover and secure it in place with the screws. 2. Locate the horizontal stabilizer on the elevator pivot assembly, and secure it to the assembly with two 3 x 8mm screws 1.5 x 8mm Phillips head self tapping 3 x 8mm Phillips head machine Propeller Installation 1. Install the Prop adapter, propeller, prop washer and nut.
EN Transmitter and Receiver Binding / Switching ON and OFF SAFE Select (BNF Basic) This product requires an approved Spektrum™ DSM2®/DSMX® compatible transmitter. Visit www.bindnfly.com for a complete list of approved transmitters. The aircraft has an optional SAFE Select feature, which can be switched ON or OFF easily by binding in a specific manner as described below.
EN Battery Installation and ESC Arming Battery Selection The Spektrum™ 2200mAh 11.1V 3S 30C Li-Po battery (SPMX22003S30) is recommended. Refer to the Optional Parts List for other recommended batteries. If using a battery other than those listed, the battery should be within the range of capacity, dimensions and weight of the Spektrum Li-Po battery packs to fit in the fuselage. Be sure the model balances at the recommended CG before flying. 1. Lower the throttle and throttle trim to the lowest settings.
EN SAFE® Select Switch Designation SAFE® Select technology can be easily assigned to any open switch (two or three position) on the transmitter. With this new feature, you now have the flexibility to enable or disable the technology while in flight. Mode 1 and 2 Transmitters IMPORTANT: Before assigning your desired switch, ensure that the travel for that channel is set at 100% in both direction. Assigning a switch 1. Bind the aircraft correctly to activate SAFE Select.
EN Center of Gravity (CG) The CG location is measured from the leading edge of the wing at the root. This CG location has been determined with the recommended Li-Po battery (SPMX22003S30). Tip: Measure the CG with the aircraft inverted. 120mm +/- 3mm back from leading edge of wing at the fuselage. AS3X Control Direction Test (BNF Basic) This test ensures that the AS3X® control system is functioning properly. Assemble the aircraft and bind your transmitter to the receiver before performing this test.
EN Flying Tips and Repairs Consult local laws and ordinances before choosing a flying location. Range Check your Radio System Before you fly, range check the radio system. Refer to your specific transmitter instruction manual for range test information. Oscillation Once the AS3X system is active (after advancing the throttle for the first time), you will normally see the control surfaces react to aircraft movement.
EN Post Flight 1. Disconnect the flight battery from the ESC (Required for Safety and battery life). 2. Power OFF the transmitter. 3. Remove the flight battery from the aircraft. 4. Recharge the flight battery. 5. Repair or replace all damaged parts. 6. Store the flight battery apart from the aircraft and monitor the battery charge. 7. Make note of the flight conditions and flight plan results, planning for future flights.
EN Problem Reduced flight time or aircraft underpowered Possible Cause Flight battery charge is low Propeller installed backwards Flight battery damaged Flight conditions may be too cold Battery capacity too low for flight conditions Transmitter too near aircraft during binding process Solution Completely recharge flight battery Install propeller with numbers facing forward Replace flight battery and follow flight battery instructions Make sure battery is warm before use Replace battery or use a larger ca
EN AMA National Model Aircraft Safety Code Effective January 1, 2018 A model aircraft is a non-human-carrying device capable of sustained flight within visual line of sight of the pilot or spotter(s). It may not exceed limitations of this code and is intended exclusively for sport, recreation, education and/or competition.
EN Limited Warranty What this Warranty Covers Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase.
EN FCC Information FCC ID: BRWSPMSR6200A Supplier’s Declaration of Conformity E-Flite Cherokee 1.3M BNF Basic (EFL54500) This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Recommended Receivers•Empfohlene Empfänger•Récepteurs Recommandés•Ricevitori Raccomandati PNP Only • Nur PNP • PNP Uniquement • Solo PNP Description SPMAR620 SPMAR6600T SPMAR8010T SPMAR9030T SPMAR636 SPMAR637T SPMAR8360T Beschreibung Ummantelter AR620-6-KanalAR620 DSMX 6-Channel Sport Receiver Flugzeugempfänger Telemetry Equipped Receivers Empfänger mit Telemetrie AR6600T-6-KanalAR6600T 6-Channel Air Integrated Flugzeugempfänger mit Telemetry Receiver integrierter Telemetrie AR8010T-8-KanalAR8010T 8-Ch
Replacement Parts • Ersatzteile • Pièces de rechange • Pezzi di ricambio Description Beschreibung Description Motor: 1.2m gekipptes Flügeljunges EFL5166 Motor: 1.2m Clipped Wing Cub EFL5451 Painted Fuselage: Cherokee 1.3m Gemalter Rumpf: Cherokee 1.3m Fuselage peint: Cherokee 1.3m EFL5452 EFL5453 Painted Wing: Cherokee 1.3m Spinner: Cherokee 1.3m Gemalter Flügel: Cherokee 1.3m Aile peinte: Cherokee 1.3m Spinner: Cherokee 1.3m Spinner: Cherokee 1.3m EFL5454 Motor Mount: Cherokee 1.
Optional Parts • Optionale Bauteile • Pièces optionnelles • Pezzi opzionali Description EFLA250 EFLAEC302 EFLAEC303 EFLB22003S30 EFLB22004S30 EFLB25003S30 EFLB32003S30 EFLB32004S30 DYNC3005 KXSC1004 DYNC2010CA SPMA3081 SPMA3065 EFLA111 DYN1405 DYN1400 Beschreibung Park Flyer Werkzeugsortiment, 5 teilig Description Descrizione Park Flyer assortimento attrezzi, Park Flyer Tool Assortment, 5 pc Assortiment d'outils park flyer, 5pc 5 pc EC3 Connettore femmina x EC3 Battery Connector, Female (2) EC3 Akkukabe
© 2020 Horizon Hobby, LLC. E-flite, DSM, DSM2, DSMX, Bind-N-Fly, BNF, the BNF logo, Plug-N-Play, AS3X, SAFE, the SAFE logo, ModelMatch, Z-Foam, Passport, Prophet, EC3, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other trademarks, service marks and logos are property of their respective owners. US 8,672,726. US 9,930,567. US 10,419,970. US 9,056,667. US 9,753,457. US 10,078,329.
