User manual

EN
ICON A5
CAUTION: Always disconnect the fl ight battery before performing motor
service.
Disassembly
1. Remove the screw (A) and spinner (B) from the collet shaft (G).
2. Use a tool to remove the spinner nut (C) from the collet shaft.
3. Remove the propeller (D), spinner backplate (E), collet backplate (F) and
collet (G) from the motor shaft.
4. Remove four screws (H) from the cowling (I).
5. Carefully remove the cowling from fuselage. Paint may keep the cowling
attached to the fuselage.
6. Remove four screws (J) from the motor mount (K) and fuselage.
7. Disconnect the motor wires from the ESC wires.
8. Remove four screws (L) and the motor (M) from the motor mount.
Keep rubber washers attached to the motor mount when removing the
screws and the motor from the motor mount.
Assembly
• Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC wires.
• Install the propeller with the size numbers (9 x 8) facing out from
the motor.
• Tighten the spinner nut to secure the propeller into place.
Motor Service
Post Flight
1. Disconnect the fl ight battery from the ESC (Required for Safety and
battery life).
2. Power OFF the transmitter.
3. Remove the fl ight battery from the aircraft.
4. Recharge the fl ight battery.
5. Repair or replace all damaged parts.
6. Store the fl ight battery apart from the aircraft and monitor the
battery charge.
7. Make note of the fl ight conditions and fl ight plan results, planning
for future fl ights.
B
GF
3 X 8mm
A
D
C
E
M
I
3 X 10mm
L
2.5X12mm (4)
J
K
2 X 8mm (4)
H
Not all wiring shown.
Optional Headlights
ICON A
5
B
A
1. Inside the fuselage, connect the headlight controller (EFLA600) connector to
an unused receiver channel.
2. Put the headlights behind the left and right headlight lenses (A) of the
fuselage.
3. Apply a small amount of glue to hold the lights in the fuselage holes (B).
We recommend the blue (EFLA603) or the white lights (EFLA602) in the ICON A5.
14