User manual

EN
ICON A5
Model Assembly Continued
Wing Installation
1. Remove the battery hatch.
2. Guide the wing tube (A) through the hole located at the top of the fuselage
as shown.
3. Slide each wing half (B) over the wing tube.
4. Connect the two aileron connectors to the aileron Y-harnesss at the root of
each wing. Place extra servo wire slack and servo connectors in the small
cavity in the root of the wing.
CAUTION: DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
5. Secure the wings into place using the two included srews (C).
IMPORTANT: The ailerons must be connected to the receiver’s AILE (#2
channel) with a Y-harness (included) for the AS3X
@
system to function properly.
6. Reinstall the battery hatch on the fuselage.
7. Disassemble in reverse order.
1.
2.
3.
4.
5.
6.
A
B
3 X 16mm (2)
C
Clevis Installation
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired hole in the
control horn.
• Move the tube to hold the clevis on the control horn.
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the control
surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of the
linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and sub-trims to
0, then adjust the clevises to center the control surfaces.
6