User manual

EN
Propeller Installation
IMPORTANT: Install the propeller after all system setups are completed to
reduce the chance of accidental propeller strike.
1. Install the collet (A) on the motor shaft (B).
2. Install the backplate (C), spinner backplate (D), propeller (E) and spinner
nut (F) on the collet shaft. Use a tool to tighten the spinner nut on the
collet shaft.
3. Install the spinner (G) on the spinner nut (F) using a screw (H). Make sure
the spinner is tight on the spinner backplate.
Model Assembly Continued
A
B
H
3 X 8mm
A
C
D
B
E
F
G
A
B
A
2 X 8mm (1)
B
2 X 8mm (6)
Fuselage Gear Covers Installation (Water takeoff
and landing)
1. Cover the nose gear hole with the nose plate using a screw (A).
2. Install the left and right rear gear covers (marked L and R) using six
screws (B).
NOTICE: When removing or installing the nose plate, ensure the O-ring is not
damaged or lost.
7