User manual

ICON A5

Main Gear Installation

1. Turn the model over so the bottom faces up.

2. Install the rear right and left landing gear struts (A) in the fuselage using six

screws (B).

Nose Gear Installation

1. Install the nose wheel post in the hole in front of the fuselage.

2. Put the Z-bend of the steering linkage (C) in the outermost hole of the

steering arm (D).

3. Carefully turn over the model so it rests on the landing gear. Put the end of

the steer linkage under the battery compartment inside the fuselage.

4. Align the steering arm with top of the nose wheel post so the arm is

oriented as shown.

5. Install screw (E) to hold the arm on top of the nose wheel post.

6. Connect the linkage clevis (behind the battery compartment) to the rudder

servo arm. See Factory Settings for an illustration of the linkages on the

servo arms.

NOTICE: Always ensure the steering linkage clevis is adjusted correctly to

make the model steer straight when the rudder control is at neutral.

If disassembled, install wheels on the rear struts using shoulder screws,

washers and nuts. Make sure the bushing side of the wheels are toward the

struts. Use a small amount of threadlock to hold the nut on the shoulder screw.

Use a small amount of threadlock on the setscrew in the wheel collar on the

nose wheel.

Model Assembly Continued

2 X 8mm (6)

2 X 8mm