User Manual

11
EN
Center of Gravity (CG)
This CG location has been determined with the recommended Li-Po battery
(SPMX32006S50).
The CG location is given below and is measured from the leading edge of the wing at the
root with the landing gear down.
The CG location is adjusted by moving the battery pack forward or backward in the
battery compartment.
NOTICE: Install the battery in the aircraft, but do not arm the ESC while checking the
CG. Personal injury may result.
AS3X Control Direction Test (BNF Basic)
This test ensures that the AS3X
®
control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle just above 25%, then lower the throttle to
activate AS3X technology.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fly the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is
normal. AS3X remains active until the battery is disconnected.
Aircraft
movement
AS3X Reaction
ElevatorAileronRudder
back from leading edge
of wing at the fuselage.
90 – 110mm
During your first flight, trim the aircraft for level flight at 3/4 throttle. Make
small trim adjustments with your transmitter’s trim switches to straighten the
aircraft’s flight path.
After adjusting the trim, do not touch the control sticks for 3 seconds. This
allows the receiver to learn the correct settings to optimize AS3X performance.
Failure to do so could affect flight performance.
In Flight Trimming (BNF Basic)
3 Seconds