User Manual

F-16 70mm EDF
6
EN
Model Assembly Continued
Nose Cone Installation
1. The nose cone held in place magnetically.
Vertical Tail Installation
1. Connect the rudder servo to the servo extension tucked into the cavity. Verify
the servo is operating correctly with your radio system before proceeding.
2. Wipe the mounting areas on the vertical tail and fuselage with a paper towel
to pick up any dust or loose paint before applying glue.
3. Tuck the rudder servo lead and connector back into the cavity .
4. Use CA glue to attach the vertical tail to the fuselage. Apply a thin layer in the
tail mounting cavity on the fuselage.
5. Attach the vertical tail to the fuselage as shown in the diagram.
6. Press the vertical stabilizer halves into position and wipe off any excess glue
that seeps out with a paper towel.
7. Leave the model level upright and ensure the vertical fin is kept accurately
aligned while the glue to cures.
Apply glue here
90˚