F-16 Falcon 80mm EDF Manual

Afterburner Ring Application
To add the optional Afterburner Ring.
1. Remove the 2 screws (A) securing the vertical fin (B) and remove the fin.
2. Remove the 2 screws (C) holding the tailcone (D) and remove the cone.
3. Connect the afterburner connector to the preinstalled servo lead found under
the vertical fin.
4. Apply contact cement (E) to the mating surface of the fuselage where the
afterburner ring (F) will fit.
5. Fit the ring to the fuselage.
6. Reinstall the tailcone and the vertical fin.
7. Unplug the ESC connector from the receiver and plug the ESC into a
Y-connector (not included). Plug the Afterburner Ring lead into the other
Y-connector and plug into the throttle channel of the receiver.
EN
F-16 Falcon 80mm EDF
10
C
D
F
E
A
B