User Manual

P-51D Mustang 1.2m

This test ensures that the AS3X

control system is functioning properly.

Assemble the aircraft and bind your transmitter to the receiver before

performing this test.

1. Raise the throttle just above 25%, then lower the throttle to activate AS3X.

CAUTION: Keep all body parts, hair and loose clothing away from a

moving propeller, as these items could become entangled.

IMPORTANT: The AR631 programming for this aircraft increases control

surface movement when aps are fully down.

2. Move the entire aircraft as shown and ensure the control surfaces move in

the direction indicated in the graphic. If the control surfaces do not respond

as shown, do not y the aircraft. Refer to the receiver manual for more

information.

Once the AS3X system is active, control surfaces may move rapidly. This is

normal. AS3X remains active until the battery is disconnected.

Aircraft

movement

AS3X Reaction

ElevatorAileronRudder

AS3X Control Direction Test

SAFE

Select Switch Designation

SAFE

Select technology can be easily assigned to any open switch (two or

three position) on the transmitter. With this new feature, you now have the

exibility to enable or disable the technology while in ight.

IMPORTANT: Before assigning your desired switch, ensure that the travel for

that channel is set at 100% in both direction.

Assigning a switch

Bind the aircraft correctly to activate SAFE Select. This will allow the system to

be assigned to a switch.

Hold both transmitter sticks to the inside bottom corners and toggle the desired

switch ve times (one toggle = full up and down) to assign that switch. The

control surfaces of the aircraft will move, indicating the switch has been

selected.

Repeat the process to deselect the switch or to assign a different switch if

desired.

TIP: SAFE Select is assignable on any unused Channels 5–9.

Mode 1 and 2 Transmitters

two or three position switch

x 5

100%