User Manual

P-51D Mustang 1.2m

Antenna Mast

Slide the antenna mast (C) into the slot (D) on top of the fuselage.

Battery Selection

We recommend the E-ite

2200mAh 11.1V 3S 30C+ Li-Po battery. Refer to

the Optional Parts List for other recommended batteries. If using a battery other

than those listed, the battery should be within the range of capacity, dimen-

sions and weight of the E-ite Li-Po battery packs to t in the fuselage. Be sure

the model balances at the recommended CG.

1. Lower the throttle and throttle trim to the lowest settings. Power on the

Transmitter, then wait 5 seconds.

2. Carefully lift the back of the canopy hatch (A) to remove.

3. Slide the battery tray (B) out of the battery compartment.

4. For added security apply the loop side (soft side) of the optional hook and loop

tape (C) to the bottom of your battery and the hook side to the battery tray.

5. Install a fully charged battery (D) on the front edge of the battery tray as

shown and secure it using the hook and loop straps (E).

6. Align the battery tray with the tracks in the battery compartment and slide

the tray all the way forward until the tray locks.

7. Connect the battery to the ESC (the ESC is now armed).

8. Keep the aircraft immobile and away from wind or the system will

not initialize.

• The ESC will sound a series of tones (refer to step 6 of the binding

instructions for more information).

• An LED will light on the receiver.

If the ESC sounds a continuous double beep after the ight battery is

connected, recharge or replace the battery.

9. Reinstall the canopy hatch.

CAUTION: Always keep hands away from the propeller. When armed,

the motor will turn the propeller in response to any throttle movement.

Optional

Optional Antenna Mast Installation

Battery Installation and ESC Arming