F-15 64mm Manual

ManualsBrandsE-flite ManualsAirplanesF-15 Eagle 64mm EDF Jet BNF Basic with AS3X and SAFE Select - SCRATCH & DENT

F-15 Eagle 64 mm

Battery Selection

We recommend the Spektrum

™

2200mAh 3S 14.8V 30C LiPo bat-

tery (SPMX22003S30), for standard operation. The ESC and motor

system are designed for both 3S and 4S LiPo batteries. If using a dif-

ferent battery, the battery should be of similar capacity, dimensions

and weight of the Spektrum LiPo battery pack. Always be sure the

model balances at the recommended CG with the battery chosen.

1. Apply the loop side (soft side) of the hook and loop tape (A) to

the bottom of your battery.

2. Install a small piece of the Hook side of the hook and loop inside

the fuselage where the battery will sit. Don’t make this too big

or the battery will be difcult to remove.

3. Carefully lift the back of the canopy hatch (B) to remove.

4. Install the fully charged battery in the battery compartment as

shown. See the Adjusting the Center of Gravity instructions for

more information.

5. Make sure the ight battery is secured.

6. Lower the throttle and throttle trim to the lowest settings. Power

on the Transmitter, then wait 5 seconds.

7. Connect the battery to the ESC (C) (the ESC is now armed).

8. Keep the aircraft immobile and away from wind or the system

will not initialize.

The ESC will sound a series of tones. If the ESC sounds a continuous double beep after the ight battery is connected, recharge or replace the

battery.

9. Reinstall the canopy hatch.

SAFE

Select Switch Designation

SAFE

Select technology can be easily assigned to any open switch

(two or three position) on the transmitter. With this feature, you now

have the exibility to switch the SAFE feature on and off while in ight.

IMPORTANT: Before assigning your desired switch, ensure that the

travel for that channel is set at 100% in both direction.

Assigning a switch

1. Bind the aircraft correctly to activate SAFE Select. This will allow the

system to be assigned to a switch.

2. Hold both transmitter sticks to the inside bottom corners and toggle

the desired switch ve times (one toggle = full up and down) to

assign that switch. The control surfaces of the aircraft will move,

indicating the switch has been selected.

Repeat the process to assign a different switch if desired. If no switch

is assigned, SAFE will be active at all times.

TIP: SAFE Select is assignable on any unused Channels 5–9

Mode 1 and 2 Transmitters

Two or three position switch

x 5

100%

Battery Installation and ESC Arming