F-15 64mm Manual

F-15 Eagle 64 mm

Post Flight

1. Disconnect the ight battery from the ESC (Required for Safety

and battery life).

2. Power OFF the transmitter.

3. Remove the ight battery from the aircraft.

4. Recharge the ight battery.

5. Repair or replace all damaged parts.

6. Store the ight battery apart from the aircraft and monitor the

battery charge.

7. Make note of the ight conditions and ight plan results, planning

for future ights.

Troubleshooting Guide AS3X

Problem Possible Cause Solution

Oscillation

Motor vibration Replace parts or correctly align all parts and tighten fasteners as needed

Loose receiver Align and secure receiver in fuselage

Loose aircraft controls Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)

Worn parts Replace worn parts (especially propeller, spinner or servo)

Irregular servo movement Replace servo

Inconsistent ight

performance

Trim is not at neutral If you adjust trim more than 8 clicks, adjust the clevis to remove trim

Sub-Trim is not at neutral No Sub-Trim is allowed. Adjust the servo linkage

Aircraft was not kept immobile for

5seconds after battery connection

With the throttle stick in lowest position. Disconnect battery, then reconnect

battery and keep the aircraft still for 5 seconds

Incorrect response to the

AS3X Control Direction Test

Incorrect direction settings in the

receiver, which can cause a crash

DO NOT y. Correct the direction settings using a AS3X programmer

Disassembly

1. Carefully remove the lower cover to gain access to the ESC. It is held on

with exible glue that can be gently pulled away.

2. Disconnect the motor connectors from the ESC.

3. To access the motor/fan unit, remove the two screws (one on each side).

4. Disassemble the motor/fan as needed.

• Assembly in reverse order.

• Make sure the spinner is fully seated on the fan blade for safe operation.

• Make sure you match the colors on the ESC wires with the colors on

the motor.

Power Components Service

CAUTION: Always disconnect the ight battery before performing

motor service.