Programming Guide

5.Timing Setup : Automatic/ Low / High.
* Automatic (7-30 deg) – ESC automatically determines the optimum motor timing
* Low (7-22 deg) – Setting for most 2 pole motors.
* High(22-30 deg)-setting for motors with 6 or more poles.
In most cases, automatic timing works well for all types of motors. However for high
efficiency we recommend the Low timing setting for 2 pole motors (general in-runners)
and high timing for 6 poles and above (general out-runners). For higher speed, High
timing can be set. Some motors require different timing setups therefore we suggest you
to follow the manufacturer recommended setup or use the automatic timing setting if you
are unsure.
Note: Run your motor on the ground first after making any changes to your motor timing!
6.Soft Acceleration Start ups: Very Soft / Soft Acceleration/ Start Acceleration
* Very Soft – Provides initial slow 1.5 sec ramp-up from start to full rpm intended to
protect delicate gears from stripping under instant load. This setting is recommended for
either fixed wing models equipped with gearboxes and / or helicopters.
* Soft Acceleration- Provides initial slow 1 sec ramp-up from start to full rpm. This
setting is recommended for either fixed wing models equipped with gearboxes and or
helicopters.
* Start Acceleration – Provides quick acceleration start ups with a linear throttle
response. This is recommended for fixed wing models fitted with direct drive setups.
7.Active RPM Control (Heli Governor mode)
* RPM Control OFF
* First Range: There will be a 5-second delay from start to full rpm, but if the throttle is
cutoff after starting, then the next start will be as normal start.
* Second Range: There will be a 15-second delay from start to full rpm, but if the throttle
is cutoff after starting, then the next start will be as normal start.
Note: Once the Governor Mode is enabled, the ESC’s Brake and Low Voltage Cutoff Type
settings will automatically be reset to No Brake and Reduce Power respectively regardless
of what settings they were previously set.