UMX Night Vapor Manual

EN
Night Vapor
4
Find a safe and open area.
Charge the flight battery.
Assemble the aircraft.
Install the transmitter batteries.
Install the flight battery.
Perform control direction test.
Plan flight for flying field conditions.
Set a flight timer for 7 minutes.
Have fun!
Preflight Checklist
Charge the Flight Battery
Charging Warnings
WARNING: Failure to exercise caution while using this
product and comply with the following warnings could
result in product malfunction, electrical issues, excessive
heat, FIRE, and ultimately injury and property damage.
• NEVER LEAVE CHARGING BATTERIES UNATTENDED.
• NEVER CHARGE BATTERIES OVERNIGHT.
• Never attempt to charge dead, damaged or wet battery packs.
• Never attempt to charge a battery pack containing
different types of batteries.
• Never allow children under 14 years of age to charge
battery packs.
• Never charge batteries in extremely hot or cold places or
place in direct sunlight.
• Never charge a battery if the cable has been pinched
or shorted.
• Never connect the charger if the power cable has been
pinched or shorted.
• Never attempt to dismantle the charger or use a
damaged charger.
• Always use only rechargeable batteries designed for use
with this type of charger.
• Always inspect the battery before charging.
• Always keep the battery away from any material that
could be affected by heat.
• Always monitor the charging area and have a fire
extinguisher available at all times.
• Always end the charging process if the battery becomes
hot to the touch or starts to change form (swell) during
the charge process.
• Always connect the positive leads (+) and negative leads
(–) correctly.
• Always disconnect the battery after charging, and let the
charger cool between charges.
• Always charge in a well-ventilated area.
• Always terminate all processes and contact Horizon
Hobby if the product malfunctions.
• Charge only rechargeable batteries. Charging non-
rechargeable batteries may cause the batteries to burst,
resulting in injury to persons and/or damage to property.
• The USB outlet shall be installed near the equipment and
shall be easily accessible.
CAUTION: Always ensure the battery you are
charging meets the specifications of this charger.
Not doing so can result in excessive heat and other
related product malfunctions, which can lead to user
injury or property damage.
CAUTION: If at any time during the charging
process the battery pack becomes hot or begins
to puff, disconnect the battery immediately and
discontinue the charge process as batteries can cause
fire, collateral damage and injuries.
NOTICE: Charge only batteries that are cool to the touch
and are not damaged. Inspect the battery to make sure it
is not damaged e.g., swollen, bent, broken or punctured.
1. Insert the charger into a USB port.
2. Slide the battery into the slot on the charger and press
it into the charge jack/connector located at the bottom
of the slot. The end cap of the battery is specifically
designed to allow the battery to fit into the slot one way
(usually with the label on the battery facing outward) to
prevent reverse polarity connection. However, check for
proper alignment and polarity.
3. Always disconnect the flight battery from the charger
immediately upon completion of charging.
CAUTION: Never exceed the recommended
charge rate.
LED Indications
When you make the connection successfully, the LED on
the charger turns solid red, indicating charging has begun.
Charging a fully discharged (not over-discharged) 150mAh
battery takes approximately 30–40 minutes. The light goes
out when the charge is complete.
CHARGING (Solid Red)
MAX CHARGE (OFF)
CAUTION: Once charging is complete,
immediately remove the battery. Never leave a
battery connected to the charger.