UMX Night Vapor Manual

EN
Night Vapor
6
Install the Flight Battery
BNF Transmitter Setup
Hook and loop tape
1. Slide the fully charged battery into the battery holder
with the connector facing the rear of the model, as
shown.
2. Connect the power lead from the ESC to the battery,
noting correct polarity.
IMPORTANT: The installed receiver has been
programmed for operation specifically in this aircraft.
To operate the various features of this aircraft, follow the
table to setup your computer transmitter.
• The flight mode selection should be assigned to a
2-position switch.
• The function of channel 6 (Aux 1) should be assigned to a
momentary switch, if available.
• If your transmitter is telemetry capable, the Night Vapor
receiver will communicate the battery voltage and
percentage as well as frame losses and holds. Navigate
to the transmitter telemetry screen to view.
Refer to your transmitter manual for more information
about transmitter setup.
Computerized Transmitter Setup
Start all transmitter programming with a blank ACRO
model (perform a model reset), then name the model.
Dual Rates
HIGH 100%
LOW 70%
DX7S
DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set SWITCH SELECT:
GEAR: Gear
TRAINER: AUX1
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1
Gear switch operates the flight modes
0 SAFE mode
1 AS3X mode
Trainer/Bind operates the LED color change
DX6e
DX6 (Gen2)
DX7 (Gen2)
DX8e
DX8 (Gen2)
DX9
DX10t
DX18
DX20
iX12
iX20
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Go to CHANNEL ASSIGN:
Channel Input Config:
GEAR: Switch A
AUX1: Button I
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse AUX1
Switch A operates the 2 flight modes
0 SAFE mode
1 AS3X mode
Button I operates the LED color change