User Manual

EN
9
Post Flight Checklist

1. Disconnect the flight battery from the ESC
(Required for safety and battery life).
2. Power OFF the transmitter.
3. Remove the flight battery from the aircraft.
4. Recharge the flight battery.

5. Store the flight battery apart from the aircraft
and monitor the battery charge.
6. Make note of the flight conditions and flight
plan results, planning for future flights.
Power Components Service
Disassembly
CAUTION: DO NOT handle the propeller while the
flight battery is connected to the ESC. Personal
injury could result.
Propeller
1. Remove the spinner (A) from the propeller.
Since the propeller and spinner are glued together, glue
residue will need to be cleaned from the spinner or
propeller when these parts are used again.
2. Carefully remove the screw (B) and propeller (C) from
the motor shaft.
Motor
1. Remove the battery hatch by gripping the front of the
hatch, then pulling it up and away from the fuselage.
2. Disconnect the motor wire connector from the ESC/
receiver connector.
3. Remove the screw (D) and motor (E) from the motor
mount.
4. Remove 3 screws (F) and the prop adapter (G) from
the motor. The motor magnet may attract screws to
the motor.
Assembly
Assemble in reverse order.
• Connect the motor wire connector to the ESC/receiver.
• The propeller size numbers (5.3 x 3.5) must face
forward for correct propeller operation.
• Ensure the propeller adapter and motor mount are fully
connected to the motor.
stretch motor to 1.75 length
A
stretch motor to 1.75 length
B
C
stretch motor to 1.75 length
E
D
G
F