User Manual

EN
5
Transmitter Setup
Install the Flight Battery
Hook and loop tape
1. Connect the power lead from the ESC to the battery,
noting correct polarity.
2. Install a fully charged battery in the middle of the
battery tray using double-sided hook and loop
material.
3. Keep the aircraft immobile and away from wind for
five seconds. Once connected to your transmiter, the
LED on the flight controller will illuminate when it is
initialized and ready for flight.
Tip: View the flight controller through the air vent on the
top front of fuselage.
Flight controller LED
LED Color Mode
Red and blue flashing Bind Mode
Solid red and blue SAFE
Solid red AS3X
IMPORTANT: The installed receiver has been
programmed for operation specifically in this aircraft.
To operate the various features of this aircraft, follow the
table to setup your computer transmitter.
• The flight mode selection should be assigned to a
2-position switch.
• There are no ailerons on this aircraft. Rudder control is
on the aileron control stick.
• If your transmitter is telemetry capable, the receiver will
communicate the battery voltage and percentage as well
as frame losses and holds. Navigate to the transmitter
telemetry screen to view after binding.
Refer to your transmitter manual for more information
about transmitter setup.
Computerized Transmitter Setup
Start all transmitter programming with a blank ACRO
model (perform a model reset), then name the model.
Dual Rates
HIGH 100%
LOW 70%
DX7S
DX8
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set SWITCH SELECT:
GEAR: Gear
Gear switch operates the flight modes
0 SAFE mode
1 AS3X mode
DX6e, DX8e
DX6, DX7, DX8
(Gen2)
DX9, DX18,
DX20
iX12, iX20
NX6, NX8,
NX10
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Go to CHANNEL ASSIGN:
Channel Input Config:
GEAR: Switch A
Switch A operates the 2 flight modes
0 SAFE mode
1 AS3X mode