User Manual

Motor Service

Disassembly

CAUTION: DO NOT handle the rotor or

motor while the ﬂight battery is connected.

Personal injury could result.

1. The lower half of the nacelle hatch is secured

to the top half using glue and clear tape.

Carefully cut the clear tape and follow the

seam with a knife to cut the glue and remove

the bottom half of the nacelle.

NOTICE: Removing tape or decals can damage

paint on your aircraft. Avoid pinching or otherwise

damaging any wires when opening or closing the

fuselage.

2. Disconnect the motor from the receiver.

3. Carefully remove the lower half of the nacelle

(A) from the upper half of the nacelle.

4. Remove the 4 screws (B) and fan unit (C)

from the upper nacelle half.

5. Put a small flat blade screwdriver in the motor

mount hole (D) and carefully push the rotor (E)

away from the motor shaft. Rotate the rotor

while prying it away from the motor (F) to avoid

bending the motor shaft.

6. Remove the 4 screws (G) and motor from

the motor mount.

Assembly

• Assemble in reverse order, connecting the

top and bottom half of the nacelle with

clear tape and or foam safe CA.

NOTICE: Always install the motor mount so that

the rotor faces the front of the fuselage and the

hole in the unit faces the bottom of the fuselage.