User Manual

15
EN
Warranty and Service Contact Information
FCC Information
IC Information
Country of Purchase Horizon Hobby Phone Number/Email Address Address
United States of
America
Horizon Service Center
(Repairs and Repair Requests)
servicecenter.horizonhobby.
com/RequestForm/
4105 Fieldstone Rd
Champaign, Illinois, 61822
USA
Horizon Product Support
(Product Technical Assistance)
productsupport@
horizonhobby.com
877-504-0233
Sales
[e-mail]
800-338-4639
United Kingdom
Service/Parts/Sales:
Horizon Hobby Limited
[e-mail] Units 1–4 , Ployters Rd,
Staple Tye Harlow, Essex,
CM18 7NS, United Kingdom
[phone]
Germany
Horizon Technischer
Service
[e-mail]
Christian-Junge-Straße 1
25337 Elmshorn, Germany
Sales: Horizon Hobby
GmbH
[phone]
France
Service/Parts/Sales:
Horizon Hobby SAS
infofrance@horizonhobby.
com
11 Rue Georges Charpak
77127 Lieusaint, France
[phone]
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.”
IC ID: 6157A-EFLAS6410NBLT
This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: Modifications to this product will void the user’s authority to operate this equipment.
FCC ID: BRWEFLAS6410NBLT