User Manual

3
EN
To register your product online, go to www.e-fliterc.com
20.3 (516mm)
22.1 in (562mm)
5.9 oz
(168 g)
Transmitter and Receiver Binding ..........................4
Low Voltage Cutoff (LVC) .......................................4
ESC/Receiver Arming, Battery Installation and
Center of Gravity ................................................... 5
Control Centering ................................................. 6
Factory Control Horn Settings................................6
Dual Rates and Expos ...........................................6
Landing Gear Removal ..........................................7
Control Direction Test ............................................8
AS3X Direction Test ...............................................9
Flying Tips and Repairs .......................................10
Motor Service .....................................................11
Post Flight Checklist ...........................................12
Troubleshooting Guide ........................................12
Troubleshooting Guide (Continued) ......................13
Limited Warranty ................................................13
Warranty and Service Contact Information ..........15
IC Information .....................................................15
FCC Information .................................................. 15
Compliance Information for the European Union .. 16
Replacement Parts ..............................................59
Optional Parts and Accessories ...........................60
Table of Contents
Specifications
Wing Area: 83.7 sq. in.
(5.40 dm2)
Preflight Checklist
Installed
(2) Motors: BL180M, 13500Kv inrunner
brushless motor
Receiver: DSMX
®
UM 6-Ch AS3X
®
w/
Twin Brushless ESC
(4) 2.3-Gram Performance Linear Long
Throw Servo (SPMSA2030L)
Required to Complete
Recommended Battery: 800mAh 2S
7.4V 30C Li-Po, (EFLB8002SJ30)
Battery Charger:
Celectra
™
2S 7.4V DC Li-Po Charger
(EFLUC1007)
Recommended Transmitter:
Full range Spektrum
™
DSM2
®
/DSMX
®
with dual-rates (DXe and up)

1. Charge flight battery.
2. Install flight battery in aircraft (once it
has been fully charged).
3. Bind aircraft to transmitter.
4. Make sure linkages move freely.
5. Perform Control Direction Test with
transmitter.
6. Perform AS3X Control Direction Test
with aircraft.

7. Set dual rates.
8. Adjust center of gravity.
9. Perform a radio system Range Check.
10. Find a safe and open area.
11. Plan flight for flying field conditions.
12. Set flight timer for 5 minutes for first
flight.