™ ® UMX Pitts S-1S Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, Inc. For up-to-date product literature, visit www.horizonhobby.com and click on the support tab for this product.
EN ® ™ ® hank you for purchasing the E-flite UMX Pitts S-1S ultra micro airplane. Despite its size, this model Tconstruction has been engineered to deliver a potent scale model that handles great. Molded lightweight foam makes it possible for the high-output brushless power system installed to provide quick acceleration and strong vertical climbs. Four performance linear long-throw servos provide precision control.
l EN Preflight Checklist 1. Charge flight battery. 6. Set dual rates and expos. 2. Install flight battery in aircraft (once it has been fully charged). 7. Adjust center of gravity. 3. Bind aircraft to transmitter. 4. Make sure linkages move freely. 5. Perform Control Direction Test with transmitter. 8. Perform a radio system Range Check. 9. Find a safe and open area. 10. Plan flight for flying field conditions.
EN Transmitter and Receiver Binding Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific transmitter. You need to ‘bind’ your chosen Spektrum™ DSM2/DSMX technology equipped aircraft transmitter to the receiver for proper operation. Any full range Spektrum DSM2/DSMX transmitter can bind to the DSM2/DSMX receiver. Please visit www. bindnfly.com for a complete list of compatible transmitters.
EN ESC/Receiver Arming, Battery Installation and Center of Gravity CAUTION: Always keep hands away from the propeller. When armed, the motor will turn the propeller in response to any throttle movement. 1 Arming the ESC/receiver also occurs after binding as previously described, but subsequent connection of a flight battery requires the following steps. AS3X The AS3X® system will not activate until the throttle stick or trim is increased for the first time.
EN Control Direction Test You should bind your aircraft and transmitter before doing these tests. Move the controls on the transmitter to make sure the aircraft control surfaces move correctly and in the proper direction. Make sure the tail linkages move freely and that paint or decals are not adhered to them. Control Centering Before the first flights, or in the event of an accident, make sure the flight control surfaces are centered.
EN Flying Tips and Repairs We recommend flying your aircraft outside in calm conditions. Always avoid flying near houses, trees, wires and buildings. You should also be careful to avoid flying in areas where there are many people, such as busy parks, schoolyards or soccer fields. Consult local laws and ordinances before choosing a location to fly your aircraft.
EN Power Components Service Disassembly CAUTION: DO NOT handle the propeller while the flight battery is connected to the ESC. Personal injury could result. Propeller A 1. Remove the spinner (A) from the propeller. Since the propeller and spinner are glued together, glue residue will need to be cleaned from the spinner or propeller when these parts are used again. C 2. Carefully remove the screw (B) and propeller (C) from the motor shaft. Motor B 1.
EN Troubleshooting Guide AS3X Problem Possible Cause Solution Control surfaces not at neutral position when transmitter controls are at neutral Control surfaces may not have been mechanically centered from factory Center control surfaces mechanically by adjusting the U-bends on control linkages Aircraft was moved after the flight battery was connected and before sensors initialized Disconnect and reconnect the flight battery while keeping the aircraft still for 5 seconds Model flies inconsistently fro
EN Troubleshooting Guide (Continued) Problem Possible Cause Solution LED on receiver flashes Less than a 5-second wait between first rapidly and aircraft will powering on transmitter and connecting not respond to transmit- flight battery to aircraft ter (after binding) Aircraft bound to different model memory (ModelMatch™ radios only) Control surface does not move Leaving transmitter on, disconnect and reconnect flight battery to aircraft Select correct model memory on transmitter and disconnect and recon
EN of Horizon. Proof of purchase is required for all warranty claims. SERVICE OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY. A copy of your original sales receipt must be included for warranty consideration. Be sure your name, address, and RMA number are clearly written on the outside of the shipping carton. Limitation of Liability NOTICE: Do not ship LiPo batteries to Horizon.
EN Warranty and Service Information Country of Purchase Horizon Hobby Phone Number/Email Address Address Horizon Service Center (Repairs and Repair Requests) United States of America United Kingdom Germany France China servicecenter.horizonhobby. com/RequestForm/ www.quickbase.com/db/ Horizon Product Support 4105 Fieldstone Rd bghj7ey8c?a=GenNewRecord (Product Technical Assistance) Champaign, Illinois, 61822 USA 888-959-2305 sales@horizonhobby.com Sales 888-959-2305 sales@horizonhobby.co.
Replacement Parts – Ersatzteile – – Pièces de rechange – Pezzi di ricambio – Part # • Nummer Numéro • Codice Description EFLU5265 EFLU5251 Description Descrizione Decal Set: UMX Pitts Dekorbogen: UMX S-1S Pitts S-1S Set de décoration: UMX Pitts S-1S Set adesivi: UMX Pitts S-1S Spinner Set (3): UMX Pitts S-1S Cônes (3) : UMX Pitts S-1S Set ogiva (3): UMX Pitts S-1S Landing Gear Set w/ E-flite UMX Pitts Wheel Pants: UMX S-1S: Fahrwerk m.
– Optional Parts and Accessories – – Optionale Bauteile und Zubehörteile – – Pièces optionnelles et accessoires – – Pezzi opzionali e accessori – Part # • Nummer Description Numéro • Codice Beschreibung Description Descrizione Ultras Micros - Bande Set fascette a strappo auto-agrippante (5) (5): Ultra Micro PKZ1039 Hook and Loop Set (5): Ultra Micros Parkzone: Klettband Set Ultra Micros EEFLB2002S25 2S 7.4V 200mAh 25C Li-Po Battery 2S 7.4V 200mAh 25C Batterie Li-Po 7.
© 2014 Horizon Hobby, Inc. E-flite, AS3X, Blade, Celectra, UMX, DSM, DSM2, DSMX, ModelMatch, Bind-N-Fly, the Bind-N-Fly logo and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, Inc. The Spektrum trademark is used with permission of Bachmann Industries, Inc. Futaba is a registered trademark of Futaba Denshi Kogyo Kabushiki Kaisha Corporation of Japan. Aviat®, Aviat Aircraft™ and Pitts® are trademarks or registered trademarks of Aviat Aircraft, Inc.
