User Manual

Power Components Service

Disassembly

CAUTION: DO NOT handle the rotor or

motor while the  ight battery is connected.

Personal injury could result.

1. Carefully cut the tape and/or decals on the side

of the fuselage to remove the top of the fuselage

to access the motor connection to the ESC.

2. Carefully cut the tape on the bottom of the

fuselage to remove the bottom compartment

cover from the fuselage to access the

motor wires.

3. Remove (2) rotor screws (A) from the rotor with

a 1.5 m screw driver or wrench.

4. Remove the rotor (B) from the motor shaft.

5. Disconnect the motor wire connector

from the ESC/receiver connector.

6. Remove the (3) motor screws (D) from the motor

mount though the back of the nacelle.

7. Remove the motor (C) from motor mount and

through the front of the nacelle.

Assembly

Assemble in reverse order, connecting the top half

of the fuselage and the bottom compartment cover

seams with clear tape.

NOTICE: Always install the motor mount so that

the rotor faces the front of the fuselage.

Wiring not shown