User Manual

10
EN
Receiver Wiring Diagram
Reference the following diagram for all wiring connections to
the receiver.
Recommended Parts List
Optional Parts
Part # Description
EFLU6455 LED Set: Ultrix
JST battery connector
Bottom View Of Airplane
Looking At The Receiver
Points to nose
of the aircraft
Left Motor Connector
Optional wing lights
Left Elevon Servo
Optional Tail lights
Right Elevon Servo
Right Motor Connector
Update Port
Problem Possible Cause Solution
Control surfaces not at neutral
position when transmitter
controls are at neutral
Control surfaces not mechanically centered
from factory
Center control surfaces mechanically by
adjusting the U-bends on control linkages
Aircraft was moved after the fl ight battery
was connected and before sensors initialized
Disconnect and reconnect the fl ight battery
while keeping the aircraft still for 5 seconds
Model fl ies inconsistently
from fl ight to fl ight
Trims are moved too far from neutral position
Neutralize trims and mechanically adjust
linkages to center control surfaces
Controls oscillate in fl ight
(model rapidly jumps or moves)
Propeller is unbalanced,
causing excessive vibration
Remove properller and motor. Check motor
shaft for straightness and replace prop if
damaged
AS3X Troubleshooting Guide
Part # Description
EFLB2801S25 500mAh 1S 25C Li-Po (EFLB5001S25)
SPMXC1040 S44 Micro 4-port AC/DC 1S LiPo Smart Charger