User Manual
5
EN
To obtain the best flight performance, we recommend using a DSM2
®
/DSMX
®
transmitter capable of Dual Rates. Before binding, ensure that you are starting
with a blank acro model in your transmitter.
IMPORTANT: After you set up your model, always rebind the transmitter
and receiver to set the desired failsafe positions.
Program Your Transmitter
1. Start with a new ACRO Model.
2. Set Aircraft Type : Wing >1Ail 1Flap
: Tail > Normal
3. Leave all settings at their default values.
The Gear Switch (ch 5) will control the Safe mode function.
• Switch position 0 = SAFE Mode
• Switch position 1 = AS3X Mode
Computerized Transmitter Setup
(DX6e, DX6 G2, DX7 G2, DX8 G2, DX9,
DX18 and DX20)
Start all transmitter programming with a blank
ACRO model (do a model reset), then name
the model.
Set Servo Travel to: 100%
F-Mode Setup
Switch 1 Inhibit
Switch 2 Inhibit
Channel Assign
Channel Input Config
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear SAFE/AS3X
6 Aux 1 FLAP
Frame Rate
22mz
DSMX
Function List
Timer 6:00
Set FLAP SYSTEM:
SELECT SWITCH
POS 0: -90% FLAP
POS 1: 0% FLAP
POS 2: 90% FLAP
Transmitter Setup
Dual Rates and Expos
The suggested settings shown here are the recommended starting settings.
Adjust according to the individual preferences after the initial flight.
NOTICE: Do not set your transmitter travel adjust over 100%. If
the TRAVEL ADJUST is set over 100%, it will not result in more control
movement, it will overdrive the servo and cause damage.
It is normal for linear servos to make significant noise. The noise is not an
indication of a faulty servo.
TIP: For the first flight, fly the model in low rate.
Dual Rates
Low
High
Aileron, Elevator, Rudder 70% 100%
100%
x 5
100%
Mode 1 and 2 Transmitters
1. Power on the transmitter.
2. Power on the aircraft.
3. Hold both transmitter sticks to the outside bottom
corners and toggle the Gear switch 5 times
(1 toggle = full up and down). The control surfaces
of the aircraft will move, indicating SAFE Select has
been enabled or disabled.
Repeat the process again to re-enable or disable
SAFE Select.
To enable and disable SAFE
®
Select Technology use the following steps.