UMX Turbo Timber BNF Basic - Manual

11
EN
Float installation (Optional)
Slat Installation (Optional)
Required Adhesives
Foam Safe CA
1. Apply a small drop of foam safe CA to each mount.
2. Carefully mount the slat onto the wing with the
rounded edge facing forward.
Landing Gear Removal
1. Carefully place the aircraft inverted.
2. Remove the 4 screws and 2 plates securing the
landing gear.
3. Remove the other 4 screws and 2 plates for the
rear float mount. Save all screws and plates for the
float installation.
4. Remove the landing gear.
Float Installation
1. Install the included rear float wire onto the floats.
2. Install the floats as shown.
3. Install the 6 screws and 4 plates removed above.