User Manual

21E-flite Enticememt F3P Profile Assembly Manual
 8. With the ailerons and aileron servo centered,
check the distance between the horns and pushrods.
There should be a 1/16-inch (1mm) gap between them.
If not, use side cutters to trim the pushrods to the correct
length.
 9. Slide the heat shrink tubing on the control horns,
then slide the pushrods into the heat shrink, centering
the heat shrink between the two. Use a soldering iron to
shrink the tubing onto the control horns and pushrods for
both ailerons.
Note: You must use a soldering iron to shrink the tubing.
The heat from other methods cannot be controlled as well
and will cause damage to your airframe.
 10. Repeat Steps 7 though 9 for the opposite aileron
pushrod installation.