EFL9350 Mini Convergence Transmitter Setup

EN
®
Transmitter Setup Quick Start Guide
This transmitter setup is recommended to all flyers
who are new to multirotor or VTOL aircraft.
This setup will put flight mode and transition selection on one switch to
eliminate confusion between switches.
Computerized Transmitter Setup
(DXe, DX6e, DX6 – DX20, and iX12*)
Start all transmitter programming with a blank ACRO (Airplane) model
(perform a model reset), then name the model.
DX6 – DX20
iX12
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set AICRAFT TYPE: WING: NORMAL
4. Set CHANNEL ASSIGN: (NEXT)
CHANNEL INPUT CONFIG: GEAR: INH
AUX1: INH
5. Set TRIM SETUP: Throttle – – 3-Pos Digital
6. Go to the FUNCTION LIST
7. Set Expo values: Elevator 10%
Aileron 10%
Rudder 0%
8. Set Servo Travel to 100% for all controls
9. D/R Low – 70%
High – 100%
10. Set Throttle Cut to -130% and Select Switch H
11. Set P-Mix 1 in the Mixing menu
Select CURVE
Select INH for the input – Select Switch D
Select INH for the output – Select AX1
Set the 3 points on the curve to
1. 100%
2. 100%
3. -100%
Set Switch: On
12. Set P-Mix 2 in the Mixing menu
Select CURVE
Select INH for the input – Select Switch D
Select INH for the output – Select GEAR
Set the 3 points on the curve to
1. -100%
2. 100%
3. 100%
Set Switch: On
®
Motors Start/Stop
Use the Throttle trim to keep the motors turning during flight at low throttle.
Move the throttle trim up to start the motors at the low throttle position. Move
the throttle trim down, or activate throttle cut to stop the motors after flight.
In this configuration there is only Stability Mode in Multirotor Flight Mode.
Stability Mode
Stability Mode limits the bank and pitch angle of the aircraft. The aircraft will
self-level if you release the transmitter sticks.
Acro Mode
Acro Mode removes the bank angle limits and will not self-level the aircraft
if you release the transmitter sticks. Acro Mode is intended for experienced
pilots who are comfortable flying the aircraft in any orientation.
The following table gives the switch positions and a brief description of the
possible flight conditions available.
Flight Conditions
Multirotor Mode
with Stability
(Switch D, Position 0)
•Limited bank angle
•Very little pitch change
•Forward and backward flight is achieved through
angling of the main motor nacelles
•Self-levelling
•Elevons inactive
•Tail motor runs
•Use this condition for all takeoffs and landings
Airplane Mode with
Stability
(Switch D, Position 1)
•Limited bank angle
•Self-levelling
•Elevons active
•Tail motor does not run
•Do not attempt to land or takeoff in this condition
Airplane Mode with
Acro
(Switch D, Position 2)
•Unlimited bank and pitch angles
•Does not self-level
•Elevons active
•Tail motor does not run
•Do not attempt to land or takeoff in this condition
Switch H – Throttle Cut
Pos 0 – Motors On
Pos 1 Motors Off
Switch D – Flight Mode
Pos 0 – Hover Mode with Stability
Pos 1 – Airplane Mode with Stability
Pos 2 – Airplane Mode with Acro
Throttle Trim
Trim 100% – Motors spin
at Idle at low throttle
Trim -100% Motors off
at low throttle
Trim 0% – Motors off at
low throttle