Instruction manual

EN
1 Remove and inspect contents.
2 Read this instruction manual thoroughly.
3 Charge the fl ight battery.
4 Fully assemble the airplane.
5 Setup Transmitter using transmitter setup chart.
6 Install the fl ight battery in the aircraft (once it has been fully charged).
7 Check the Center of Gravity (CG).
8 Bind the aircraft to your transmitter.
9 Make sure linkages move freely.
10 Test the retract operation.
11 Test the fl ap operation.
12 Perform the Control Direction Test with the transmitter.
13 Perform the AS3X Control Direction Test with the aircraft.
14 Adjust fl ight controls and transmitter.
15 Perform a radio system Range Test.
16 Find a safe open area to fl y.
17 Plan fl ight for fl ying fi eld conditions.
To register your product online, visit www.e-fl iterc.com
Table of Contents
42.8 oz
(1214 g)
Model Assembly ................................................................................4
Control Horn and Servo Arm Settings .................................................5
Transmitter Setup .............................................................................6
PNP Receiver Selection and Installation .............................................7
Transmitter and Receiver Binding .......................................................7
Battery Installation and ESC Arming ...................................................8
Center of Gravity (CG) .......................................................................9
Control Direction Tests .......................................................................9
AS3X Control Direction Test ............................................................10
Flying Tips and Repairs ....................................................................11
Post Flight .......................................................................................12
Power Component Service ...............................................................12
Troubleshooting Guide AS3X ...........................................................13
Troubleshooting Guide .....................................................................14
AMA National Model Aircraft Safety Code .........................................15
Limited Warranty .............................................................................16
Contact Information .........................................................................17
FCC Information ...............................................................................17
IC Information ..................................................................................17
Compliance Information for the European Union ...............................17
Replacement Parts ...........................................................................62
Optional Parts ..................................................................................63
Specifi cations
BL15 Brushless Outrunner Motor, 950Kv (PKZ5116) Installed Installed
E-fl ite 30-Amp Pro Brushless ESC
(EFLA1030B)
Installed Installed
(2) Aileron Servos (PKZ1081)
(1) Rudder Servo (1) Elevator Servo (1) Flap Servo
(PKZ1090)
Installed Installed
Spektrum
™
AR636, 6-Channel Sport Receiver (SMAR636) Installed
Required to
Complete
Battery: 11.1V 3S 2200mAh 30C Li-Po (EFLB22003S30)
Required to
Complete
Required to
Complete
Battery Charger: 3-cell Li-Po battery balancing charger
Required to
Complete
Required to
Complete
Recommended Transmitter:
Full-Range 6 channel (or more) 2.4GHz with Spektrum
DSM2
®
/DSMX
®
technology with adjustable Dual Rates.
Required to
Complete
Required to
Complete
Prefl ight
Box Contents
Quick Start Information
Transmitter
Setup
Setup your transmitter using the
transmitter setup chart.
Dual Rates
High Low
100% 70%
Flight Timer
Setting
First fl ight 5 Min. 7 Min.
44 in (1120mm)
38.4 in (975mm)
3