EFL8850 E-flite Sukhoi SU-29MM Gen 2 Manual

Sukhoi SU-29MM

During your ﬁ rst ﬂ ight, trim the aircraft for level ﬂ ight at 3/4 throttle. Make

small trim adjustments with your transmitter’s trim switches to straighten the

aircraft’s ﬂ ight path.

If more than 4 clicks of trim are required for straight and level ﬂ ight, land the

aircraft and cycle the power OFF/ON. This will allow the receiver to learn the

correct trim settings to optimize AS3X performance.

AS3X Control Direction Test

This test ensures that the AS3X

control system is functioning

properly.

Assemble the aircraft and bind your transmitter to the receiver before

performing this test.

1. Raise the throttle just above 25%, then lower the throttle to

activate AS3X technology.

CAUTION: Keep all body parts, hair and loose clothing away

from a moving propeller, as these items could become entangled.

IMPORTANT: The AR636 programming for this aircraft increases

control surface movement when landing gear is down.

2. Move the entire aircraft as shown and ensure the control surfaces

move in the direction indicated in the graphic. If the control sur-

faces do not respond as shown, do not ﬂ y the aircraft. Refer to the

receiver manual for more information.

Once the AS3X system is active, control surfaces may move rapidly.

This is normal. AS3X remains active until the battery is disconnected.

In Flight Trimming

Aircraft

movement

AS3X Reaction

ElevatorAileronRudder