Ultra Micro Timber Manual

5
EN
To obtain the best fl ight performance, we recommend using a DSM2
®
/
DSMX
®
transmitter capable of Dual Rates. Before binding, ensure that
you are starting with a blank acro model in your transmitter.
IMPORTANT: After you set up your model, always rebind the
transmitter and receiver to set the desired failsafe positions.
Program Your Transmitter
1. Start with a new ACRO Model.
2. Set Aircraft Type: Wing >1Ail 1Flap
: Tail > Normal
3. Leave all settings at their default values.
The Gear Switch (ch 5) will control the Safe mode function.
• Switch position 0 = SAFE Mode
• Switch position 1 = AS3X Mode
Computerized Transmitter
Setup
(DX6e, DX6 G2, DX7 G2, DX8 G2, DX9,
DX18 and DX20)
Start all transmitter programming with
a blank ACRO model (do a model reset),
then name the model.
Set Servo Travel to: 100%
F-Mode Setup
Switch 1 Inhibit
Switch 2 Inhibit
Channel Assign
Channel Input Confi g
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear SAFE/AS3X
6 Aux 1 FLAP
Frame Rate
22mz
DSMX
Function List
Timer
6:00
Set FLAP SYSTEM:
SELECT SWITCH
POS 0: -90% FLAP
POS 1: 0% FLAP
POS 2: 90% FLAP
Transmitter Setup
Dual Rates and Expos
The suggested settings shown here are the recommended
starting settings. Adjust according to the individual preferences
after the initial fl ight.
NOTICE: Do not set your transmitter travel adjust over 100%.
If the TRAVEL ADJUST is set over 100%, it will not result in more
control movement, it will overdrive the servo and cause damage.
It is normal for linear servos to make signifi cant noise. The noise
is not an indication of a faulty servo.
Tip: For the fi rst fl ight, fl y the model in low rate.
Dual Rates
Low High
Aileron, Elevator, Rudder 70% 100%
x 5
Mode 1 and 2 Transmitters
1. Power on transmitter.
2. Hold sticks in lower outside corners.
3. Toggle the Channel 5 switch fi ve times.
To enable and disable SAFE® Select Technology use the following steps.