EFLU5850 E-flite Ultra-Micro UMX Aero Commander BNF Manual

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identi er)

code of a single speci c transmitter. You need to ‘bind’ your chosen Spektrum

™

DSM2/DSMX technology

equipped aircraft transmitter to the receiver for proper operation.

Any full range Spektrum DSM2/DSMX transmitter can bind to the DSM2/DSMX receiver. Please visit www.

bindn y.com for a complete list of compatible transmitters.

Transmitter and Receiver Binding



Binding Procedure

CAUTION: When using a Futaba transmitter with a Spektrum DSM

module, you must reverse the

throttle channel and rebind. Refer to your Spektrum module manual for binding and failsafe instructions.

Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.

1. Refer to your transmitter’s unique instructions for binding to a receiver (location of transmitter’s

Bind control).

2. Make sure the  ight battery is disconnected from the aircraft.

3. Power off your transmitter.

4. Set the aircraft upright on its wheels and connect the flight battery in the aircraft. The receiver

LED will begin to flash rapidly (typically after 5 seconds)

5. Make sure the transmitter controls are neutral and the throttle and throttle trim are in low position.

6. Put your transmitter into bind mode. Refer to your transmitter’s manual for binding button or

switch instructions.

7. After 5 to 10 seconds, the receiver status LED will turn solid, indicating that the receiver is bound

to the transmitter. If the LED does not turn solid, refer to the Troubleshooting Guide at the back of

the manual.

For subsequent  ights, power ON the transmitter for 5 seconds before connecting the  ight battery.