EFLU5850 E-flite Ultra-Micro UMX Aero Commander BNF Manual

5
EN
To obtain the best  ight performance,
we recommend using a DSM2
®
/DSMX
®
transmitter capable of Dual Rates. Before
binding, ensure that you are starting with a
blank acro model in your transmitter.
IMPORTANT: After you set up your model,
always rebind the transmitter and receiver
to set the desired failsafe positions.
Program Your Transmitter
1. Start with a new ACRO Model.
2. Set Aircraft Type: Wing >1Ail 1Flap
: Tail > Normal
3. Leave all settings at their default
values.
Computerized Transmitter Setup
(DX6e, DX6 G2, DX7 G2, DX8 G2, DX9, DX18 and DX20)
Start all transmitter programming with a blank ACRO model
(do a model reset), then name the model.
Set Servo Travel to: 100%
F-Mode Setup
Switch 1 Inhibit
Switch 2 Inhibit
Channel Assign
Channel Input Con g
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear
6 Aux 1
Frame Rate
22mz
DSMX
Funtion List
Timer
Mode Count Down
Time 6:00
Start Throttle Out
Over 25%
One Time Inhibit
Transmitter Setup
Dual Rates and Expos
The suggested settings shown here are the
recommended starting settings. Adjust according to
the individual preferences after the initial  ight.
NOTICE: Do not set your transmitter travel adjust
over 100%. If the TRAVEL ADJUST is set over
100%, it will not result in more control movement, it
will overdrive the servo and cause damage.
It is normal for linear servos to make signi cant
noise. The noise is not an indication of a faulty
servo.
Tip: For the  rst  ight,  y the model in low rate.
Dual Rates
Low High
Aileron 70% 100%
Elevator 70% 100%
Rudder 70% 100%