EFLU6050 E-flite UMX MiG-15 EDF BNF Manual

10
EN
Service of Power Components
Disassembly
CAUTION: DO NOT handle the rotor or motor
while the fl ight battery is connected. Personal
injury could result.
1. The canopy hatch is secured to the fuselage using
double-sided tape under the outside edge. Carefully
remove the canopy hatch, the screw (A) and nose gear
arm (B); replacing the double-sided tape as needed.
NOTICE: Removing tape or decals can damage paint on
your aircraft. Avoid pinching or otherwise damaging any
wires when opening or closing the fuselage.
2. Disconnect the motor connector from the receiver.
3. Turn over the aircraft so that the landing gear faces up.
4. Cut the tape and decals on the fuselage and carefully
remove the lower fuselage (C).
A
B
C
5. Remove the 4 screws (D) and fan unit (E) from the
upper fuselage.
6. Put a small flat blade screwdriver in the motor mount
hole (F) and carefully push the rotor (G) away from the
motor shaft. Rotate the rotor while prying it away from
the motor to avoid bending the motor shaft.
7. Remove the 4 screws (H) and motor (I) from the motor
mount.
Assembly
Assemble in reverse order, connecting the top and bottom
half of the fuselage with clear tape and the canopy hatch
with double stick tape.
NOTICE: Always install the motor mount so that the rotor
faces the front of the fuselage and the hole in the unit
faces the bottom of the fuselage.
Assembly
A
ssemble in reverse order, connecting the top and bottom
h
al
f
o
f
the
f
usela
ge
with clear t
ape
and the can
opy
hatch
wi
t
h
d
ou
bl
e st
i
c
k
ta
p
e.
NO
TI
C
E:
Al
w
ays
i
nsta
ll
t
h
e motor mount so t
h
at t
h
e rotor
faces the front of the fusela
g
e and the hole in the unit
f
aces the bottom o
f
the
f
usela
ge.
D
E
F
G
H
I