EFLU6050 E-flite UMX MiG-15 EDF BNF Manual

4
EN
1. Gently slide the left and right main landing gear
into the plastic mounting clips on the bottom
of the wings as shown. The main gear are
configured for a left and right side.
Installing the Optional Landing Gear
2. Carefully slide the nose gear into the plastic
nose gear mount on the bottom of the fuselage.
TIP: The nose gear strut wire can be twisted
a small amount to adjust the ground tracking.
Always remove the nose gear from the aircraft
before performing this adjustment.
Prefl ight Checklist
Installing the Optional Cannons
1 Remove and inspect contents.
2 Read the instruction manual thoroughly.
3 Charge the fl ight battery.
4 Install the optional landing gear.
5 Program your transmitter.
6 Install the fully charged fl ight battery in the aircraft.
7 Check the center of gravity (CG).
8 Bind the aircraft to your transmitter.
9 Make sure all linkages move freely.
10 Perform the control direction test.
11 Adjust the fl ight controls and transmitter as needed.
12 Perform a radio system range test.
13 Find a safe open area to fl y.
14 Plan fl ight for fl ying fi eld conditions.
Install the cannons in the nose of your aircraft as shown.
Use the sharp end of the cannons to make a hole in the
foam of each location. The cannons can be glued in or
flown with just a friction fit.
The optional cannons are for scale appearance.
Belly landing the aircraft with them installed is not
recommended as they may get caught in the ground cover
and cause damage to the airframe.