EFLU6050 E-flite UMX MiG-15 EDF BNF Manual

Transmitter and Receiver Binding

Binding is the process of programming the receiver of the control unit to recognize the GUID (Globally Unique Identiﬁ er)

code of a single speciﬁ c transmitter. You need to ‘bind’ your chosen Spektrum

DSM2

/DSMX

technology equipped

aircraft transmitter to the receiver for proper operation.

For subsequent ﬂ ights, power on the transmitter for 5 seconds before connecting the ﬂ ight battery.

1 2

If you accidentally connect the battery while the throttle is fully raised, the ESC will enter programming mode. Disconnect

the battery immediately.

The AS3X system will not activate until the throttle stick or trim is increased for the ﬁ rst time. Once the AS3X is active, the

aircraft control surfaces may move rapidly. This is normal.

AS3X will remain active until the battery is disconnected.

NOTICE: Always keep material or debris away from the intake. When armed, the rotor will turn in response to the

throttle movement and could ingest any loose objects.

Arming the ESC

Arming the ESC also occurs after binding as previously described, but subsequent connection of a ﬂ ight battery requires

the steps below.

Lower throttle and throttle trim

to lowest settings.

Power on the transmitter then

wait 5seconds

Install the ﬂ ight battery and

connect it to the ESC.

Keep plane immobile and

away from wind for 5

seconds.

Series of tones

Slow ﬂ ashing green LED

Binding Procedure

1. Refer to your transmitter manual for instruction on binding the transmitter to a receiver.

2. Ensure the ﬂ ight battery is not connected to the aircraft.

3. Depending on your transmitter, either power off the transmitter or ensure the RF signal is off.

4. Connect the ﬂ ight battery to the aircraft. The receiver green and red LEDs will begin to ﬂ ash rapidly (typically after 5 seconds).

5. Make sure the transmitter controls are at neutral and the throttle and throttle trim are in the low position.

6. Place the transmitter in bind mode. Refer to your transmitter manual for binding instructions.

7. After 5-10 seconds, the receiver green LED will ﬂ ash slowly, indicating the receiver board is bound to the transmitter.

If the LED does not ﬂ ash slowly, refer to the Troubleshooting Guide at the back of the manual.