EFLU3350 E-flite UMX P-51 BL Manual

10
EN
Power Components Service
Disassembly
CAUTION: DO NOT handle the propeller
while the fl ight battery is connected to the ESC.
Personal injury could result.
Propeller
1. Remove the spinner (A) from the propeller.
Since the propeller and spinner are glued
together, glue residue will need to be cleaned
from the spinner or propeller when these parts
are used again.
2. Carefully remove the screw (B) and propeller
(C) from the motor shaft.
Motor
1. Carefully cut the tape and/or decals on the
side of the fuselage to remove the top of the
fuselage.
2. Disconnect the motor wire connector
from the ESC/receiver connector.
3. Remove the screw (D) and motor (E) from the
motor mount.
4. Remove 3 screws (F) and the prop adapter (G)
from the motor. The motor magnet may attract
screws to the motor.
Assembly
Assemble in reverse order.
• Connect the motor wire connector to the ESC/
receiver.
• The propeller size numbers (4.5 x 3.0) must
face out from the motor for correct propeller
operation.
• Attach the spinner the propeller using foam
compatible CA (cyanoacrylate adhesive).
• Ensure the propeller adapter and motor mount
are fully connected to the motor.
• Assemble the fuselage using clear tape.
A
B
C
E
D
G
F