EFL4950 E-flite Valiant 1.3 BNF Manual

EN
Model Assembly
Main Landing Gear Installation
1. Remove the battery compartment door (A) from the bottom of the fuselage.
1. Slide the pre assembled landing gear (B) into the fuselage as shown.
1. Secure with the 4 screws (C).
2. Re-install the battery hatch.
A
B
C
Tail Installation
1. Install the Vertical stab (A) over the Horizontal stab (B) by sliding the 2
plastic tabs down through the holes in the horizontal stab, creating a
complete tail assembly.
TIP: You may wish to secure the vertical and horizontal stabs with a thin piece of
double sided tape.
1. Place the tail assembly (C) onto the fuselage by first inserting the front of
the vertical stab into the fuselage.
2. Lower the back of the assembly down onto the fuselage, lining up the 2
plastic tabs with the 2 holes in the fuselage.
1. Secure the tail with 2 screws (D) inserted from the bottom of the fuselage
and 1 screw (E) into the tail wheel bracket as shown.
IMPORTANT: DO NOT over tighten the screws.
2. Attach the clevis to both the elevator and rudder control horns (see
instructions for clevis connection).
Tail Wheel Installation
1. Slide the tail wheel assembly (A) into the slot in the bottom of the rudder as
shown.
2. Rotate the assembly until it locks into the clamps moulded into the tail
wheel bracket.
A
D
E
B
C
A
5