EFL1850 X-VERT Manual

EN
5
Fli ght Mode Switch
0 = Multirotor Mode
1 = Stability Mode, Forward Flight
2 = Acro Mode, Forward Flight*
Bind Switch/
Motor Arm/Disarm Switch
Throttle Cut
†
A
B
C
D
E
F
G
* The RTF version of the X-VERT is shipped with only Multirotor and Stability fl ight modes active. Flight mode switch positions 1 and 2 both access Stability Mode,
indicated by the red LED on the fl ight control board. To access Acro Mode in the RTF version, see the Flight Modes section.
†
Activating the throttle cut switch while the motors are armed will immediately disarm the motors. You must return the throttle cut switch to the “arm” (0) position and
then use the motor arm/disarm switch to re-arm the motors.
Installing the DXe Transmitter Batteries (RTF)
The LED indicator fl ashes and the transmitter beeps progressively faster as the
battery voltage drops.
Replace the transmitter batteries when the transmitter begins to beep.
DXe Transmitter Control (RTF)
ABCDEF G
Mode 1
Aileron (Left/Right)
Throttle (Up/Down)
Throttle
Trim
Aileron
Trim
ON/OFF
Switch
Rudder
Trim
Elevator
Trim
Rudder (Left/Right)
Elevator (Up/Down)
Mode 2
Aileron (Left/Right)
Elevator (Up/Down)
Elevator
Trim
Aileron
Trim
ON/OFF
Switch
Rudder
Trim
Throttle
Trim
Rudder (Left/Right)
Throttle (Up/Down)
Dual Rate Switch
LED Indicator