Installation Guide
6
3. Using a 5/16” drill bit, drill out the
holes for the nut cap/threaded rod on
the sides of the ladder.
Recommended procedure for this:
• Using the holes in the Upper Hook
Assembly as a drill guide, drill
a ⁄” hole halfway through the
thickness of the ladder slide rail
(1)
.
• Drill the same hole on the opposite
side of the Upper Hook Assembly,
producing a ⁄” through hole in
the ladder side rail
(2)
.
• Follow this same procedure for all
four through holes and complete
the assembly by securing the top
roller guide with the supplied nut
caps and threaded rod
(3 - 5)
.
Step 3 Ladder Hardware Installation
Top Ladder Hardware
1. On the outside of each ladder side rail, measure down 2” from the top of the ladder
and draw a 1½” line from the back edge of the side rail
(figure 14 - see the next page for
complete measurements)
.
2. Align the top edge of the Upper Hook Assembly with the line. Clamp or hold the
hardware in place to drill the through holes in the side rail
(figure 15)
.
Figure 15Figure 14
1
3
2
4
5